Forum Overview :: American McGee's Honda Civic

I have one ethernet cable and want to hook up my PC and 360 to it. by Worm 12/30/2011, 12:49am PST The ethernet cable is coming out of a Netgear WGR614 and I'm using a dirt old Netgear RP114 to "split" the connection. It was working fine until I tried to enable DHCP or open ports or do anything at all with it. I'm not sure if that's because it's old or because my feeble brain can't get RIP set up properly. I probably should replace it but with what? A switch, a hub, a ball of solder?

I have one ethernet cable and want to hook up my PC and 360 to it. by Worm 12/30/2011, 12:49am PST     Re: I have one ethernet cable and want to hook up my PC and 360 to it. by jeep 12/30/2011, 11:11am PST         Using a proper switch just makes the 360 disconnect immediately NT by Worm 01/08/2012, 11:28pm PST             Diagram this shit NT by Entropy Stew 01/09/2012, 12:33am PST                 I think I just got a bad switch, it was like 12 bucks by Worm 01/09/2012, 2:12am PST     You know, you can buy a 3 foot cable for under 6 bucks. Or less on eBay NT by Tansin A. Darcos (TDARCOS) 01/09/2012, 7:54am PST         I'm like two floors away from the router if doing another run was easy NT by I would have don it 01/09/2012, 9:41am PST     Probably DHCP circular routing by Tansin A. Darcos (TDARCOS) 01/09/2012, 8:21am PST         It's happening with hubs, switches, and routers so I don't think it's that. by Worm 01/09/2012, 9:48am PST             Re: It's happening with hubs, switches, and routers so I don't think it's that. by Tansin A. Darcos (TDARCOS) 01/10/2012, 4:33pm PST